Bowl Gouge Set-Up Blocks #woodturning #woodworking #lathe #howto #woodwork #shorts #shortvideo

Details: Written by Ron Brown; Category: Video Archive Ron Brown's Best; Published: 29 September 2024; Hits: 106

Thanks for watching! You can purchase the featured product below: https://www.longworthchuck.com/index.php?route=product/product&path=30&product_id=417 If enjoy the content please subscribe! Ron Thanks for watching!

You can purchase the featured product below:

https://www.longworthchuck.com/index.php?route=product/product&path=30&product_id=417

If enjoy the content please subscribe!

Ron

Creating a Four-Inch Sphere With Five Specific Sizes #woodturning #woodlathe #woodworking #howto

Make your spheres even more perfect with 5 specific sizes from us: 2, 2.5, 3, 3.5, and 4 inches! With just 3/8 of an inch extra, you'll get the perfect look! Get yours now! Watch the full video: https://youtu.be/YlxlnT4tI5I Read more ...

Tool Rest Height

Ron discusses how to determine the proper tool rest height for a wood lathe. More info at www.ronbrownsbest.com Read more ...

Amazing ToughSphere Jig

Amazing ToughSphere Jig New Product Introduction Sept. 2024 A Sphere Jig that doesn't bounce or vibrate excessively. Thanks for watching! You can find all of our products on our website below: www.ronbrownsbest.com Read more ...

How to Use 80 Grit Abrasive: Safety Tips for Avoiding Injury #disksander #woodturning #diy #lathe

Note of caution: 80 grit industrial abrasive can be dangerous if used improperly! Use light pressure and a slow RPM and keep your fingers away from the moving abrasive. Protect your fingers and hands Read more ...

Longworth Chuck Riser Rings

A simple inexpensive solution when making a knife edge plate, platter or bowl. These simple plastic spacers raise the vessel above the surface to protect the delicate edge when removing the tenon on the Read more ...